This is an old revision of the document!
LED Color Codes
- WHITE ⇒ GREEN: normal operation
- BLUE: bootloader mode (FX3 failed to initiate but is programmable via USB)
- Faint or pulsing RED: low power - use AUX power supply
- RED: FX3 failed to initiate
Note: When programming the FX3
AUX power should be removed SFP module should be removed The goal is to get the FX3 into Bootloader Device mode
First Method
- Close SCC
- Power off camera (unplug USB)
- Make sure no SFP modules are attached
- Plug in USB
- Relaunch SCC
- Using SCC Upgrade the FX3
- IF THIS FAILS
Second Method
- Power Camera off for 10 minutes (same as first method with 10 minute reset)
- If LED is Blue camera has reset to bootloader device
- Goto Third Method
- IF THIS FAILS
Third Method
- Download Cypress USB Control center from Cypress's Control Center utility
- Download FX3 img file from this location (FX3 build# 53 for production version of Gen 3 camera)
- Plug in USB cable
- Launch Cypress USB Control Center - CCC
- If you see SUB2r USB3.0 HD Camera in the left panel
- USE SCC to update the FX3 or go to Alternative step 1
- If you see Cypress FX3 USB Bootloader Device Choose this
- Choose Program
- Choose FX3
- Choose SPI Flash
- From the drop down menu select the file location you saved the FX3 img file to and OPEN SUB2r_FX3_1_1_#_#_##.img
- Bottom left hand side message should read Programming of SPI FLASH in Progress…
- Bottom left hand side message should read Programming of SPI FLASH Succeeded
- Camera is now reprogrammed and functional
Alternative if CCC sees device as SUB USB3.0 HD Camera
- From SCC select Expert Tab
- From the drop down select FPGA Console…
- First drop down menu will indicate Check if BL is Running - select drop down
- Chose Bootloarder mode
- RUN
- OK
- Camera should now appear in CCC as a Cypress FX3 Bootloader Device
- Go to Step 6 of Third Method