This is an old revision of the document!

LED Color Codes

• WHITE to GREEN normal
  
• BLUE – bootloader mode FX3 failed to initiate but is programmable via USB
  
• Faint or pulsing RED – low power use AUX power supply
  
• RED – FX3 failed to initiate
  

Note: When programming the FX3

     AUX power should be removed
     SFP module should be removed

First Method
1. Power cycle camera.
2. Make sure no SFP modules are attached
3. Close SCC
4. Relaunch SCC
5. Using SCC Upgrade the FX3
6. IF THIS FAILS

Second Method
7. Power Camera off for 10 minutes
8. If LED is Blue camera has reset to bootloader device
9. Using SCC Upgrade.
10. IF THIS FAILS

Third Method\\ 6. Download Cypress USB Control center from wiki.sub2r
7. Download FX3 img file from Wiki.sub2r FX3 upgrade gone wild
8. Plug in USB cable
9. Launch Cypress USB Control Center - CCC
10. If you see SUB2r USB3.0 HD Camera in the left panel
11. USE SCC to update the FX3*
12. If you see Cypress FX3 USB BootLoader Device Choose this
13. Choose Program
14. Choose FX3
15. Choose SPI Flash
16. From a drop down menu select the file location you saved the FX3 img file to SUB2r_FX3_1_1_4_5_53.img
17. *OR expert mode FPGA menu 2 Bootloader mode