Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
manual:camera_manual [2018/01/25 05:17] – ↷ Page name changed from manual:manual to manual:camera_manual Igor Yefmov | manual:camera_manual [2022/04/04 23:32] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 61: | Line 61: | ||
{{: | {{: | ||
- | Fine tuning can be accomplished with the help of a standard MTF card. | + | Fine tuning can be accomplished with the help of a standard |
- | {{: | + | {{: |
=== Lens cleaning === | === Lens cleaning === | ||
Line 91: | Line 91: | ||
* Strobe – synch timing out | * Strobe – synch timing out | ||
* Synch – frame synch timing in | * Synch – frame synch timing in | ||
- | - **USB3.1 Type C.** This port is a USB3.1 hybrid which means it has no vertical orientation to the plug. It will work either way. It is important to note that while this is a 3.1 connector, the camera currently only supports USB 3.0.\\ {{: | + | - **USB 3.1 Type C.** This port is a USB3.1 hybrid which means it has no vertical orientation to the plug. It will work either way. It is important to note that while this is a 3.1 connector, the camera currently only supports USB 3.0.\\ {{: |
- **RJ45 shown will be replaced with [[https:// | - **RJ45 shown will be replaced with [[https:// | ||
- {{: | - {{: | ||
Line 112: | Line 112: | ||
{{: | {{: | ||
- | ===== Top Plate ===== | + | ===== Top plate ===== |
Most of the active electronic components are located on the top of the processor board. There is a layer of compressible thermal compound that connects the top of the processor board to the bottom of the top plate. Most of the heat in the camera is transferred via the top plate. | Most of the active electronic components are located on the top of the processor board. There is a layer of compressible thermal compound that connects the top of the processor board to the bottom of the top plate. Most of the heat in the camera is transferred via the top plate. | ||
Line 124: | Line 124: | ||
The air vents are located on the back plate as 3 sets of vertical openings and the left and right microphone grills on the front plate. These vents allow some flow of air through the camera and provide a path for any heat not transferred to the housing to escape. | The air vents are located on the back plate as 3 sets of vertical openings and the left and right microphone grills on the front plate. These vents allow some flow of air through the camera and provide a path for any heat not transferred to the housing to escape. | ||
- | ==== Mounting | + | ==== Mounting |
There are 2 common ways of physically attaching the camera: | There are 2 common ways of physically attaching the camera: | ||
* standard ¼ X 20 tripod threaded hole in the bottom plate | * standard ¼ X 20 tripod threaded hole in the bottom plate |