Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision | ||
manual:fpga [2017/10/16 08:21] – created Richard Neumann | manual:fpga [2018/04/27 02:18] – Igor Yefmov | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== Specification for SUB2r Camera ===== | ===== Specification for SUB2r Camera ===== | ||
^Parameter^Specification^ | ^Parameter^Specification^ | ||
- | |Model|| | + | | || |
- | |FPGA|Xilinx Artix-7 100T| | + | ^ Model ^^ |
- | |Image | + | | FPGA|[[https:// |
- | |Video Formats|YUV| | + | | Image sensor|Interchangeable |
- | | |YUV-Cinema RGGB| | + | | |
- | | |NV12| | + | |:::|YUV-Cinema RGGB| |
- | |Video Output|| | + | |:::|NV12| |
- | | Primary|USB3.0 type C| | + | | Max resolution/ |
- | | Secondary|SFP+ SDI| | + | ^ Video Output |
- | |OS|Windows 10/Linux| | + | | Primary|USB3.0 type C| |
- | |Image Control| | | + | | Secondary|SFP+ SDI\\ Internal expansion supports 3 additional SFP+ channels\\ with Hirose BM14B(0.8)-20DS-0.4V(53) connector| |
- | | on sensor|I2C| | + | | OS|Windows 10/Linux/%%MacOS%%| |
- | | post sensor|UVC 1.5| | + | | |
- | |Power IN|| | + | ^ Image Control |
- | ||USB3.0 5vDC| | + | | on sensor|I²C| |
- | ||USB3.1 5vDC 3A| | + | | post sensor|UVC 1.1| |
- | ||AUX 5vDC 3A| | + | ^ |
- | Power Out|| | + | | |
- | ||2.5/ | + | | |
+ | | | ||
+ | ^ | ||
+ | | | ||
+ | ^ AUX I/O ^^ | ||
+ | | JTAG|FPGA program/ | ||
+ | | GPIO|Direct sensor access| | ||
+ | | Synch|✔| | ||
+ | | Strobe|✔| | ||
+ | | Camera | ||
+ | ^ Audio ^^ | ||
+ | | On-board mic|dual -26dB| | ||
+ | | AUX|3.5mm 4pole| | ||
+ | | Stereo Out|✔| | ||
+ | | Mic in|✔| | ||
+ | ^ Visual | ||
+ | | Programmable RGB LED|✔| | ||
+ | ^ Software bundle OS support | ||
+ | | Live video preview|Windows 10| | ||
+ | | [[sub2r_control_center|Camera control center]]|Windows 10| | ||
+ | | [[fx3_device_windows_10_driver|Drivers]] to access non-UVC camera interfaces|Windows 10, version 1511+ (build 10586+)| | ||