In the simplest terms the “brightness” of a pixel is its luminosity value as perceived by a human eye (making infrared and gamma rays \(0\) “bright”). There are quite a few competing standards and definitions of what the means exactly, but for our purposes we will use the \(L\) component of the HSL color space as our “brightness” value of a pixel.
Again, in the simplest terms, increasing or reducing pixel's brightness can be interpreted as adding or subtracting a fixed “gain” value (others may argue that a more natural approach would be to use a multiplier, while others still may bring the “vibrancy” approach into picture).
The mathematically correct way to do the brightness is to first convert into HSL color space, adjust the L (luma) component, and then convert back into RGB. That gives the correct result but costs way too many transistors and cycles. So we've got to improvise!
Here's the algorithm to follow, assuming \(R, G, B \in [0..4095]\) and \(br \in [-1024..+1023]\):
To calculate luminosity we just find the max and min of the triplet and get a simple average: \[L = \frac{min(R, G, B)+max(R, G, B)}{2}\]
Brightness adjustment is a trivial addition, clamping the value to its proper limits:
\[ L` = L + br \\ L` \in [0..4095] \]
The slope \(k_R\) for the red component calculation depends on whether \(L\) is above or below the middle: \[ k_{R} = \begin{cases} R / L & \text{if} \; L \leq 2047 \\ \frac{R - 4095}{L - 4095} & \text{if} \; L > 2047 \end{cases} \]
Finding the “middle point” value also depends on whether the \(L\) is above or below the middle: \[ R = \begin{cases} k_R * 2047 & \text{if} \; L \leq 2047 \\ 4095 - k_R * 2047 & \text{if} \; L > 2047 \end{cases} \]
If we are crossing the middle luma boundary as the result of this adjustment - flip the slope: \[ k_R = 2 - k_R \]
Applying the new \(L`\) to R component and clamping the result is trivial:
\[ R` = k_R * (L` - 2047) + R \\ R` \in [0..4095] \]
\(G\) and \(B\) calculations are similar to \(R\).
When using the HSL color space the adjustment is as simple as elementary school's arithmetic operation. Namely - just a simple addition.
With that the implementation of the Brightness adjustment can be as simple as the following (where the “luma”, or brightness component \(\in[0..100]%%\)):
// pseudo-code void brightness(/*array of pixels*/image, int _br){ for(const & pixel: image){ pixel.luma = std::clamp(pixel.luma + _br, 0, 100); } }