This is an old revision of the document!
Quick start guide for setting up SUB2r camera
If you only plan to be using the standard UVC controls you can just plug-n-play the camera (ignoring the “unknown devices” that are not recognized by the OS). However, if you plan on taking full advantage of the provided functionality and access all the internal camera controls with our SUB2r control center
application - proceed with the instructions on this page.
Windows driver
In order to access the camera's functions beyond the standard UVC you need this Cypress FX3 driver. Follow these steps:
- Unzip the package
- right-click on the
cyusb3
file which displays itstype
asSetup Information
(or has an.inf
extension if you have those enabled to be displayed) and selectInstall
- Confirm the
Open
operation - Confirm the Windows's account access verification
- Make sure the Publisher is shown as
SUB2r
and proceed with the installation - Now you have the driver installed
SUB2r control center
Get the SUB2r control center
application from Windows Store and install it. If the link doesn't work - just go to Windows Store
and search for SUB2r control center
there.
Ready-set-go!
Connect the camera...
… and wait for Windows to configure it
Done
Start using SUB2r control center
and enjoy our product!
For more information see:
Manual or a Tech. specification | Link |
---|---|
Basic User Manual (camera) | user manual |
SUB2r control center user manual | SUB2r control center |
Tech. specs of the main board | FPGA |
Tech. specs of camera boards | camera boards |
Specs for lenses | lenses |
Tech. specs of the SFP+ modules | SFP+ |