Differences

This shows you the differences between two versions of the page.

--- manual:quick_start_guide [2018/01/23 10:01] – [SUB2r control center] Igor Yefmov
+++ manual:quick_start_guide [2021/06/25 23:01] (current) – removed Igor Yefmov
@@ Line 1: / Line 1: @@
-====== Quick start guide for setting up SUB2r camera ======
-===== Windows driver =====
-In order to access the camera's functions beyond the standard UVC you need this Cypress FX3 driver
-[[manual:fx3_device_windows_10_driver|Windows driver]] page with a link to [[http://download.sub2r.com/SUB2r_driver_Windows10.zip|download the driver itself]] as a ''.zip'' file
-    - Unzip the package {{ :manual:sub2r-driver-unzip-1.png?nolink |Unzip - begin}} {{ :manual:sub2r-driver-unzip-2.png?nolink |Unzip - proceed}}
-    - right-click on the ''cyusb3'' file which displays its ''type'' as ''Setup Information'' (or has an ''.inf'' extension if you have those enabled to be displayed) and select ''Install'' {{ :manual:sub2r-driver-install-1.png?nolink |Right-click => Install}}
-    - Confirm the ''Open'' operation {{ :manual:sub2r-driver-install-2.png?nolink |}}
-    - Confirm the Windows's account access verification {{ :manual:sub2r-driver-install-3.png?nolink |}}
-    - Make sure the //Publisher// is shown as ''SUB2r'' and proceed with the installation {{ :manual:sub2r-driver-install-4.png?nolink |}}
-    - Now you have the driver installed {{ :manual:sub2r-driver-install-5.png?nolink |}}
-===== VC++ redistributable =====
-  - <del>Download and install VC++ 2017 redistributable for 64-bit from [[https://support.microsoft.com/en-us/help/2977003/the-latest-supported-visual-c-downloads|Microsoft's site]] (if you don't have this installed the ''SUB2r control center'' will silently(!) fail to launch with no error message)</del>
-===== SUB2r control center =====
-Get the ''SUB2r control center'' application from [[https://www.microsoft.com/en-us/store/p/sub2r-control-center/9n1bsssd7m6g|Windows Store]] and install it. If the link doesn't work - just go to ''Windows Store'' and search for ''SUB2r control center'' there.
-===== Ready-set-go! =====
-==== Connect the camera ====
-And wait for Windows to configure it
-{{ :manual:sub2r-driver-win-config-1.png?nolink |Driver auto-config - discovery}}
-{{ :manual:sub2r-driver-win-config-2.png?nolink |Driver auto-config - success}}
-==== Done ====
-Start using ''SUB2r control center'' and enjoy our product!