Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
code:fx3_hvci_and_fpga_i_c_commands [2019/11/13 00:27] – [0xA8-0xA9 - sysinfo and debugging] Igor Yefmov | code:fx3_hvci_and_fpga_i_c_commands [2020/05/14 22:05] – external edit 127.0.0.1 |
---|
| |
====== FX3 Host Vendor Command Reference ====== | ====== FX3 Host Vendor Command Reference ====== |
| Please refer to [[code::fx3_vr_cmd|Vendor Request Commands' reference]] page for details. |
| |
The following tables provide information on how to access the camera's functionality for ''FX3 Host Vendor Command Interface''. The address space is split into smaller chunks, grouped by common functionality: | The following tables provide information on how to access the camera's functionality for ''FX3 Host Vendor Command Interface''. The address space is split into smaller chunks, grouped by common functionality: |
|FPGA control|''0x06''|R/W| |Global control of the FPGA's functionality| | |FPGA control|''0x06''|R/W| |Global control of the FPGA's functionality| |
|:::|:::|:::|''7'' FPGA config enable|If bit ''7'' is set, the GPIF becomes read only and waits for an update bitstream| | |:::|:::|:::|''7'' FPGA config enable|If bit ''7'' is set, the GPIF becomes read only and waits for an update bitstream| |
|:::|:::|:::|''6'' Reserved| | | |:::|:::|:::|''6'' on-board fan| (FPGA-72+) ''1'' turns the on-board fan on, ''0'' turns it off | |
|:::|:::|:::|''5'' RAW Mode|Setting bit ''5'' and clearing bit ''0x06::2'' will enable RAW mode output (4K Only)| | |:::|:::|:::|''5'' RAW Mode|Setting bit ''5'' and clearing bit ''0x06::2'' will enable RAW mode output (4K Only)| |
|:::|:::|:::|''4'' Video Format|Bit ''4'' selects between NV12 ('1') and YUY2 ('0') output formats | | |:::|:::|:::|''4'' Video Format|Bit ''4'' selects between NV12 ('1') and YUY2 ('0') output formats | |